1/10/2024 0 Comments Macspice set editor to vimNow type 'set number relativenumber'.Īfter toggling it, you will see that the line on which your cursor is on has an absolute line number and rest of the lines have a relative line number. This will let Vim know that you are typing a command. Start writing the command by pressing the ':' (colon) key.Using commands requires you to be in the Normal mode, so make sure you are in the Normal mode.If you want to temporarily enable/disable hybrid line numbers, below are the steps to take so: In my opinion, it is the best of both worlds where you want to know the line number that you are working on and also see the relative numbers up and below the current line. When the hybrid numbering mode is on, the line on which your cursor is at the moment will have absolute number while every other line will have relative numbers. Hybrid line numbers is a mixture of absolute line numbers and relative line numbers. In any case that you want to undo this behavior, you should remove the line that says 'set relativenumber' from the '.vimrc' file of your user. Now, when you will open Vim, you will always have relative line numbers enabled. Type set relativenumber in '.vimrc', save and exit out of it.Open the '.vimrc' file using Vim: vim ~/.vimrc.To make this permanent, you need to set this option in your user's 'vimrc' file. You are wondering how to make this change permanent, instead of typing ':set relativenumber' every time you open Vim. You tried relative line numbers, and you liked it. If the relative line numbers are already toggled, setting this option will disable relative line numbers. The same nifty trick applies for relativenumber: If the relative line numbers are turned off, you can turn them on using ':set relativenumber!' or with ':set rnu!' command for short. This will entirely disable the left column that shows the line numbers. You will see relative line numbers to the above and below the line that your cursor is on.įor any reason, if you do not end up liking it, you can turn off relative line numbering using the ':set norelativenumber' command or with 'set nornu' command for short. Now type 'set relativenumber', or you can type 'set rnu' (for short) and hit the Enter key. There should be a colon character printed to the bottom-left corner of Vim. Showing relative line numbers in Vim from an active Vim session You do not have to do the mental math of subtracting the current line number from the line number, and you can go to a specific line in Vim easily. This is particularly useful because moving the cursor up and down x number of lines gets easier. When you have relative line numbers enabled, it means that the line you are currently on is line number 0 and the lines above and below the cursor are consecutively numbered 1, 2, 3. If you no longer wish to have them, simply delete the line 'set number' from your user's '.vimrc' file. Next time you open Vim, you will always see absolute line numbers in Vim. Open the '.vimrc' file using your favourite text editor - vim ~/.vimrc.If you want changes to be permanent, you can save your preferences in a '.vimrc' file that lives in your user's home directory. The same goes for ":set nonumber!" command. If the line numbers are already displayed and you use this command again, it will stop showing line numbers. You should now see line numbers to the left side of the window.įor any reason, if you do not end up liking it, you can turn it off using the ':set nonumber' command or with 'set nonu' command for short.Īctually, ":set number!" command works like a switch. ![]() ![]() Now type 'set number', or you can type 'set nu' (for short) and hit the 'Enter' key. There should be colon character printed to the bottom left corner of Vim. You can switch to the command mode by pressing the Escape (Esc) key.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |